DelphiFAQ Home Search:

Brake pedal gives no resistance after bleeding brakes


commentsThis article has not been rated yet. After reading, feel free to leave comments and rate it.


After replacing the flexible hoses, calipers, pads and shoes on my car, I bled the brakes and then came to test them. When I push the brake pedal, I feel hardly any resistance until the pedal is about 2 thirds down, after which I can feel normal resistance. What is going on?
Do I need to replace the master cylinder?


If the brakes worked somewhat well with a much harder pedal before the brake job, I wouldn't be so quick to condemn the master cylinder. Often times the piston is jammed in the caliper, preventing sufficient travel to push the pads against the rotor. However, because the pedal is traveling too far before any pressure builds, I would definitely suspect air or a leak in the system. If you used a pressurized bleeder, you may not have an air free system now. Since you replaced hoses and calipers, you have to ensure enough fluid is pumped into the system to displace all the air in the hoses and caliper cylinders. Try pumping the pedal through full travel several times while monitoring reservoir level and pedal pressure. (Don't open the reservoir while pumping the pedal.) Try bleeding the system again being careful to ensure the master cylinder reservoir is always close to full. The pressure bleeder should automatically take care of these things, but check to see that it is in fact doing so.

Content-type: text/html


2007-10-08, 18:06:11
anonymous from United States  
Not sure yet.
2009-12-26, 18:03:03
murphybrown from United States  
The rear brake shoes need to be adjusted so that there is a little bit of tension when you turn the wheel. then you will have a full pedal.
2010-04-23, 18:42:54
anonymous from Argentina  

This image was also posted here:
Dating scammer Yulia




NEW: Optional: Register   Login
Email address (not necessary):

Rate as
Hide my email when showing my comment.
Please notify me once a day about new comments on this topic.
Please provide a valid email address if you select this option, or post under a registered account.

Show city and country
Show country only
Hide my location
You can mark text as 'quoted' by putting [quote] .. [/quote] around it.
Please type in the code:

Please do not post inappropriate pictures. Inappropriate pictures include pictures of minors and nudity.
The owner of this web site reserves the right to delete such material.

photo Add a picture: