perl CGI (3)
Visual Basic (1)
Using octal data
This article has not been rated yet. After reading, feel free to leave comments and rate it.
Question:Why isn't my octal data interpreted correctly?
Answer:Perl only understands octal and hex numbers as such when they occur as literals in your program. If they are read in from somewhere and assigned, no automatic conversion takes place. You must explicitly use oct() or hex() if you want the values converted. oct() interprets both hex ("0x350") numbers and octal ones ("0350" or even without the leading "0", like "377"), while hex() only converts hexadecimal ones, with or without a leading "0x", like "0x255", "3A", "ff", or "deadbeef".
This problem shows up most often when people try using chmod(), mkdir(), umask(), or sysopen(), which all want permissions in octal.